I have some recordings that need both beginning and ending clipping, and commercial removal as well. Can this be done with a single pass? At the moment, I have to run show analyzer, which works perfectly in my case, convert, then go into custom cuts, and run another conversion through, a second time…

Are you using CustomCuts with a profile that does no transcoding at all - just applies the cuts? I think that would do the trick. However, I don’t think there is a way to use CustomCuts with MCEBuddy processing the file without it selecting the same original profile (e.g. based on the “.mp4” filena…

Thanks for that. I’m definitely not alone. What about running just Show Analyzer, and Custom Cuts if needed, and some how ending up with the correct EDL or XML file to do the job? I tried that in Windows 7 Pro, and it would start processing, but couldn’t make it through to the end. Since Show Analyz…

When custom cuts sends a file to MCEBuddy to be processed it’s tagged as a Manual file, you can create a profile and link it today the Manual/CLI monitor location in the conversion task settings. In that task advanced settings you can also set the Start trim and End trim settings to the start and e…

I figured @Goose would have already put it into MCEBuddy. :grinning: :+1: LOL. The main challenge, for me, is that the intro varies so a fixed “cut X seconds from the start” setting won’t help me.

[imagen] Goose: When custom cuts sends a file to MCEBuddy to be processed it’s tagged as a Manual file, you can create a profile and link it today the Manual/CLI monitor task in the conversion task settings I could not find the location of this: “Manual/CLI monitor task in the conversion task…

[imagen] Linking Monitor Locations and Conversion Tasks General Support / Questions FYI, Monitor Locations has now been moved to the Conversion Task → Advanced Settings page: [image]

Haciendo una sola pasada de conversión

General Support / Questions Profiles

Goose (Goose) 20 Enero, 2022 00:33 7

Tema		Respuestas	Vistas
CustomCuts GUI - How do I use it properly? General Support / Questions	4	2901	5 Octubre 2017
Custom Cuts - How to Use with post-processed media? Custom Cuts	1	1743	24 Marzo 2020
Add support for multiple conversion profiles and the ability to assign them to different tasks General Support / Questions	21	3394	28 Febrero 2023
Custom Cuts Not Cutting Custom Cuts	6	71	29 Marzo 2025
MCEBuddy skipping commercial cuts set by Custom Cuts Custom Cuts commonissues	9	2302	4 Abril 2019

Haciendo una sola pasada de conversión

Temas relacionados