I was checking GPU usage on a whim and noticed that every conversion is only using 30% of the GPU on my AMD 5700G. I checked everywhere I can think of looking for a setting that would increase the GPU utilization to like… 75% or something. How can I do this?

If you are using H.265, I think that it mostly uses CPU even if you have NVENC on Nvidia, so I assume it might do the same on AMD cards. I find that H.264 generally uses much more of the GPU. FYI, the GPU adds a good amount to the file size, so CPU encoding isn’t quite so bad in that respect. I r…

I did a few more tests… I ran 3 simultaneous conversions and it still set around 30% GPU. I did a conversion from an MKV to MP4 with and without hardware acceleration. Both the same size. This doesn’t kill me at all since I’ve been using mcebuddy for years now. It just seems strange to me.

It’s not the container that matters but rather what’s being done during the conversion that determines how much hardware GPU is utilized. See this post [imagen] Hardware usage - low % Hardware Encoding Depends on the video filters being used in the profile and the hardwar…

GPU se estanca en 30%

General Support / Questions Codificación por hardware

RBoy (RBoy) 22 Septiembre, 2023 13:23 4

No es el contenedor lo que importa, sino lo que se hace durante la conversión lo que determina cuánto hardware GPU se utiliza. Vea este post

Tema		Respuestas	Vistas
Trying to run 4 concurrent conversions makes machne and MCEBuddy unresponsive General Support / Questions	17	1082	24 Diciembre 2020
HEVC encoding using FFMPEG using 30+% of cpu Hardware Encoding tweaking	8	4465	26 Abril 2021
Slow conversiion time with Nvidia GPU enabled Hardware Encoding	1	154	29 Abril 2024
Hardware usage - low % Hardware Encoding	6	1514	22 Diciembre 2019
Is my nVidia GPU actually doing the encoding? Hardware Encoding	5	5013	19 Marzo 2020

GPU se estanca en 30%

Temas relacionados